Switch Scan Test - Oki C911 Maintenance Manual

Oki Data CONFIDENTIAL
5.3.2.3

Switch scan test

The switch scan test is used for checking IN sensors and switches.
1. Enter the self-diagnostic mode (level 1) and, until "SWITCH SCAN" appears
on the upper display, press the MENU
displays the next test option and the MENU button displays the preceding test
option). Then press the OK button.
sWitcH scan
2. Press the MENU or MENU
unit to test appears on the lower display (the MENU
option and the MENU button displays the preceding option).
3. Press the OK button. The switch scan test starts, the unit's name and current
status being displayed
in1 in2 in3 Fin
1=H 2=L 3=H 4=L
Operate the unit (figure 5-1/5-2). Display information on applicable LCD display
(the information displayed vary depending on the sensor.Refer to table 5-3.)
4. Press the CANCEL button to return to the state in step2.
5. Repeat steps 2 through 4 when necessary.
6. Press the BACK button to end the test (the state in step 1 is restored.)
45530603TH Rev.2
or MENU button (the MENU button
button until an option shown in table 5-3 for the
button displays the next
FD Stacker Full sensor
EXIT3 sensor
Sag sensor
EXIT2 sensor
EXIT1 sensor
FU Stacker Full sensor
DUPLEX IN sensor
DUPLEX Bottom sensor
DUPLEX Rear sensor
Figure 5-1-1 Switch sensor locations (Paper sensor)
5. MAINTENANCE MENUS
IN3 sensor
Paper thickness sensor
IN2 sensor
MPT Paper end sensor
MPT Last sheet detection sensor
Tray1 IN1 sensor
DUPLEX front sensor
Tray1 paper end sensor
Tray1 paper near end sensor
Tray2 IN1 sensor
Tray2 paper end sensor
Tray2 paper near end sensor
Tray3 IN1 sensor
Tray3 paper end sensor
Tray3 paper near end sensor
Tray4 IN1 sensor
Tray4 paper end sensor
Tray4 paper near end sensor
Tray5 IN1 sensor
Tray5 paper end sensor
Tray5 paper near end sensor
5-20