Batteries - AgaMatrix WaveSense JAZZ Owner's Manual

21

Batteries

CAUTION: When the battery symbol appears, you should
replace the batteries immediately. Only use CR2032 or
DL2032 batteries.
Your AgaMatrix WaveSense JAZZ Meter comes with two pre-
installed, CR2032, 3 volt, lithium batteries. Battery #1 powers
the backlight and battery #2 powers the basic meter functions.
When the power from battery #2 is low, the low battery symbol
or dead battery symbol will be displayed on the screen until
you change battery #2.
Two replacement CR2032, 3 volt, lithium batteries are included
in the pocket of your meter's carrying case.
When replacing battery #2, the time and date information
may be lost after the battery is removed from the meter. If this
happens, activate the meter after installing the new battery
and it will prompt you to set the time and date. Correct time
and date settings are needed to get correct averages.
Removing the batteries does not affect the meter's memory or
previously stored user settings, such as time format, alarms, etc.
Note: Dispose of used batteries according to your local environ-
mental regulations. Your meter is an electronic device. When dis-
posing of your meter follow all local environmental regulations.
60
8100-02301 Rev G Artwork, Guide, Owners, mmol/L, AgaMatrix, WaveSense Jazz SEC, UK
Replacing the Batteries
[1] Open Battery Door: Make sure the meter is
deactivated. Turn the meter so you are looking
at the battery door. Press the battery door clip
to open. Remove the battery door. Be careful
not to misplace the battery door.
[2] Remove and Install the meter battery:
To remove the used battery, pull the appropriate
tab to pop out the battery. A replacement battery
is included in the pocket of your meter's carrying
case. Locate and install the new battery with the
positive (+) sign facing up towards you.
[3] Remove and Install the backlight
battery: To remove the used battery,
pull the appropriate tab to pop out the
battery. Install the new battery with the
positive (+) sign facing up towards you.
[4] Close Battery Door: Angle the battery
door back onto the meter and swing down
until it snaps gently into place. Make sure
that the battery door is completely closed
before using.
CR2032
CR203 CR203 CR2032
CR2032 CR2032
CR2032
CR2032
CR2032
CR2032 CR203 CR2032
61