Batteries - AgaMatrix Liberty Owner's Booklet

Batteries

Your Liberty™ Meter comes with two pre-installed,
CR2032, 3 volt, lithium batteries.
If your batteries run low, the battery symbol fl ashes until
you change the batteries. The backlight is automatically
disabled in all modes when the battery symbol is on.
When changing batteries the current time and date set-
tings will be reset to 01-01 12:00. The correct time and
date settings are needed to get correct averages (see
pages 62-67).
Removing the batteries does not aff ect the meter's mem-
ory or previously stored user settings, such as those set in
SET Options (e.g. calibration code, alarms, etc.).
If a battery is installed incorrectly it will damage the other
battery in the meter. If this happens discard both batteries.
CAUTION: When the battery symbol appears, you should
replace the batteries immediately. Only use CR2032 batteries.
76 Batteries
Replacing the Batteries
Open Battery Door
Make sure the meter is powered OFF.
Turn the meter so you are looking at the
battery door. Press the battery door clip
to open. Remove the battery door. Be
careful not to misplace the battery door.
Remove and Install 1 st Battery
To remove the used battery, use a non-
metallic tool at point A to pop out the
battery. Install the new battery with the
positive (+) sign facing up towards you.
nd
Remove and Install 2 Battery
Repeat previous step for the 2
battery.
Close Battery Door
To close, angle the battery door back
onto the meter and swing down until it
snaps gently into place. Make sure that
the battery door is completely closed
before using.
Used
New
A
A
nd
Batteries 77