Caring For Your Meter And Lancing Device - AgaMatrix WaveSense JAZZ Owner's Manual

IMPORTANT: When the meter is deactivated and you are
replacing battery #2, the time and date information may
be lost after the battery is removed from the meter. If
this happens, activate the meter after installing the new
battery and it will prompt you to set the time and date.
Time and Date Setting After Battery Replacement
If the date and time need to be set, the word "SET" will be
displayed the first time the meter is activated.
Note: The meter retains the date and time format [24 or 12 hour
time, M-d (Month-Day) or d-M (Day-Month)]
[1] Set the year (flashing) with the DOWN ( )
or UP ( ) arrow buttons. Press the TICK ( )
button to confirm your selection.
[2] Set the month (flashing) with the DOWN
( ) or UP ( ) arrow buttons. Press the TICK ( )
button to confirm your selection.
[3] Set the day (flashing) with the DOWN ( ) or
UP ( ) arrow buttons. Press the TICK ( ) button
to confirm your selection.
62
8100-02301 Rev G Artwork, Guide, Owners, mmol/L, AgaMatrix, WaveSense Jazz SEC, UK
[4] Set the hour (flashing) with the DOWN ( ) or
UP ( ) arrow buttons. Press the TICK ( ) button
to confirm your selection.
[5] Set the minute (flashing) with the DOWN ( )
or UP ( ) arrow buttons. Press the TICK ( ) but-
ton to confirm your selection. If the meter was
activated via strip insertion, pressing TICK ( )
allows you to perform a test. If the meter was
activated via the TICK ( ) button, the meter will
enter menu mode.
22
Caring For Your Meter
and Lancing Device
When using your meter, avoid getting dirt, dust, blood, control
solution, water or any other liquid into the test strip port and
battery compartment. Clean the outside of the meter or the
lancing device using a cloth dampened with mild detergent
or mild soap. If you wish to clean the lancing device cap only,
remove the cap, wash it in warm water, rinse well, and dry.
CAUTION: Never immerse the meter or the body of the
lancing device in water or any other liquid solution.
63