Batteries - AgaMatrix WaveSense JAZZ Owner's Manual

21

Batteries

CAUTION: When the battery symbol appears, you should
replace the batteries immediately. Only use CR2032 batteries.
Your AgaMatrix WaveSense JAZZ Meter comes with two
pre-installed, CR2032, 3 volt, lithium batteries. Battery #1
powers the backlight and battery #2 powers the basic meter
functions. When the power from battery #2 is low, the low
battery symbol or dead battery symbol will be displayed on
the screen until you change battery #2. When replacing bat-
tery #2, the time and date information may be lost after the
battery is removed from the meter. If this happens, activate
the meter after installing the new battery and it will prompt
you to set the time and date. Correct time and date settings
are needed to get correct averages. Removing the batteries
does not affect the meter's memory or previously stored user
settings, such as time format, alarms, etc.
Note: Dispose of used batteries according to your local environ-
mental regulations. Your meter is an electronic device. When dis-
posing of your meter follow all local environmental regulations.
59