How To Test Your Blood Glucose Level - AgaMatrix WaveSense JAZZ Owner's Manual

IMPORTANT: Out-of-range results may be due to one or
more of the following factors:
[1] Expired or defective control solution.
[2] Expired or defective test strip.
[3] Error in performing test.
[4] Watered-down control solution.
[5] Meter malfunction.
[6] Control solution test done outside the system operating
temperature of 10 °C to 40 °C (50 °F to 104 °F).
[7] Failure to shake the control solution bottle vigorously
before using.
[8] Failure to discard the fi rst drop of control solution and to
wipe the bottle tip clean.
CAUTION: Results from control solution tests do not refl ect
your blood glucose level. The control solution range is a
target range for control solution only. It is not a target
range for your blood glucose level.
22
8100-02301 Rev G Artwork, Guide, Owners, mmol/L, AgaMatrix, WaveSense Jazz SEC, UK
8
How to Test Your
Blood Glucose Level
CAUTION: To ensure accurate results, wash your hands with
warm, soapy water and dry before every test. Make sure
there is no grease, oil or lotion on the test site. Use lancets
only once. Do not use any lancet or lancing device that has
been used by another person. Unwashed hands may lead to
inaccurate results.

How to test your blood glucose level:

[1] Preparing the AgaMatrix Lancing Device: Use the gray
cap for testing on a fingertip and the clear cap for testing on
the palm (at the base of the thumb) or forearm.
Remove Lancing Device Cap:
Snap off the cap from the
lancing device.
Insert New Lancet: Insert a new
AgaMatrix Lancet firmly into the
lancet holder cup. Pushing the
lancet into the lancet holder cup
may cock the device; this is OK.
Twist the Lancet Cover Off : Hold
the lancet firmly in place with
one hand and use your other
hand to twist off the lancet
cover. Do not discard the lancet
cover. It should be used when discarding your used lancet.
23