Serial Ata Hard Disk Drive Connection - Asus P5W User Manual

•
•

Serial ATA hard disk drive connection

Connector
SATA1
SATA 3/SATA4
5. JMicron
This connector is for a Serial ATA signal cable for a Serial ATA hard disk drive
that you can combine with an external Serial ATA 3.0 Gb/s device to configure
a RAID 0, and RAID 1 set through the onboard Jmicron
controller. Refer to Chapter 5 for details on how to set up Serial ATA RAID
configurations.
P5W SATA RAID connector
The JMicron
allowing you to enable the hot-plug function for the external device. Set to [Raid]
to use the connector to build a RAID set. See section "4.4.6 Onboard Device
Configuration" for details.
2-
To build RAID 1, we recommend that you install the hard disk drives on
the ASUS EZ-Backup connectors (EZ_RAID1 and EZ_RAID2) to enjoy the
instant setup; otherwise, you may also install on the ICH7R connectors.
You may install an extra hard disk drive on.the JMicron Serial ATA
connector after using up the Intel
connectors
Color
Red
Black
JMB363 Serial ATA connector (7-pin SATA_RAID1 [black])
®
®
JMB363 Controller item in the BIOS is set to [Basic] by default,
®
ICH7R and ASUS EZ-Backup
®
Setting
Master Boot disk
Slave Data disk
SATA_RAID1
Chapter 2: Hardware information
Use
JMB363 SATA RAID
®