Table of Contents
Advertisement
Ringer Controls
Changing the Ringer Volume
Setting the Ringer Timeout
38DHB0002UKCK - Issue 4 (07/00)
While altering the volume, the phone rings.
To change the ringer volume:
1. Without lifting the handset, press FEATURE .
2. Short-chirp: Dial 30 (ringer volume).
3. Double-tone: Dial your passcode. If you make a mistake, dial
to restart entry. You will hear either:-
• Deep double-ring: Passcode not accepted.
Dial the passcode again or press FEATURE to stop.
• Repeated ringing: Passcode accepted.
Dial
for the next volume level. Repeat until you hear the
volume preferred, then dial #.
• Short-chirp: Press FEATURE to finish.
The ringer timeout controls several actions:
• Callback: How long a callback rings before cancelling.
• Group hunting: How long calls to a group of which your 2010 is a
member, ring your 2010 before trying another number.
• Divert on no answer: How long calls ring at your phone before
the system uses Divert on No Answer if set.
To set the ringer timeout:
1. Without lifting the handset, press FEATURE, .
2. Short-chirp: Dial 13 (ringer timeout)
3. Double-tone: Dial your passcode. If you make a mistake, dial
to restart entry (see page 23). You will hear either:-
• Deep double-ring: Passcode not accepted.
Either dial the passcode again or press FEATURE to stop.
• Double-ring: Timeout already set.
Either dial
to cancel it or press FEATURE to stop.
• Single-ring: Timeout already set.
Either dial a timeout (0 to 999 seconds where 10 seconds ≈ 3
rings) or press FEATURE to stop.
• Short-chirp: Press FEATURE to finish.
Ringer Controls – Page 21
INDeX 9.1 2010 User Guide
Advertisement
Table of Contents
