Table of Contents
Advertisement
Optional Variable Speed Blower
155631
CONNECT THE GAS SUPPLY TO THE
STOVE BEFORE INSTALLING THIS
BLOWER. USE A 90° ELBOW OFF THE
GAS VALVE TO CREATE ADEQUATE
GAS LINE CLEARANCE.
THIS BLOWER MUST BE ELECTRICALLY
GROUNDED IN ACCORDANCE WITH LO-
CAL CODES OR, IN THE ABSENCE OF LOCAL
CODES, WITH THE CURRENT ANSI/NFPA 70,
NATIONAL ELECTRICAL CODE OR CSA C22.1-
CANADIAN ELECTRICAL CODE.
THIS UNIT IS SUPPLIED WITH A THREE-
PRONG (GROUNDING) PLUG FOR PRO-
TECTION AGAINST SHOCK HAZARD AND
SHOULD BE PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED THREE-PRONG
RECEPTACLE. DO NOT CUT OR REMOVE THE
GROUNDING PRONG FROM THE PLUG.
ALWAYS DISCONNECT THE POWER SUPPLY
WHEN PERFORMING ANY SERVICE ON THE
FIREPLACE INSERT.
4
Use Lower
Holes for
GF200 DV II
9
7
5
3
Figure 51. Blower Kit Components
6
2
1
Blower Installation
1. Unpack and check the contents of the blower kit. There
is a steel bracket that is not used with the GF 200
stove. Contact your dealer if any damage is evident or
parts are missing. See fig. 51.
2. Attach the Control Box to the lower pair of holes on
the Snapstat Bracket with two #8 x 1/2" sheet metal
screws as shown in figs. 51 and 52.
3. Attach the Control Box assembly to the studs located
underneath the stove in the middle of the firebox floor
using two M6 hex nuts and a 10 mm socket driver or
wrench. See fig. 52.
4. Use two M6 hex nuts to attach the Blower to the
mounting holes at the rear of the stove bottom plate.
5. Connect the power cord to 110 AC house current.
Contents
1. Blower
7
2. Snapstat Wire Harness
3. Control Box
4. Snapstat Bracket
5. Rheostat Knob
6. Snapstat
7. M6 Flange Nuts, (2)
8. M6 x 12 Hex Bolts, (2)
9. #8 x 1/2" Sheet metal screw, (4)
Tools Required
• 1/4" socket driver
• 10 mm socket driver or wrench
8
139587_05 GF 200 DV IPI October 2015
27
Hide quick links:
Advertisement
Table of Contents
