Table of Contents
Advertisement
IPAC Server Administrator's Manual
Special Options for Devices: Salto Routers and Salto Door Locks
NOTE :
Before the installation and configuration of any Salto products with
the IPAC Server, please follow all preliminary instructions from Salto
to ensure the Salto router or Salto door locks are properly
configured. Please refer to the Salto Quick Start Guide on the Brivo
website for further details.
The following equipment is required to install and configure Salto equipment on the IPAC
Server.
A laptop running Windows Vista or later for use with the Salto executable file
•
The PPD (Portable Programming Device) using firmware version 1.23 or later
•
Additionally, the Salto router MUST be configured along with any nodes prior to configuring
any Salto door locks.
The Salto routers and door locks feature allows administrators to install and configure Salto
wireless door locks.
To create a Salto Router:
1. Scroll over the Configuration link. The sub-navigation menu displays.
2. From the sub-navigation menu, click Devices from the dropdown list. The Device
List page displays.
3. Click Create New Device.
4. From the dropdown menu, select Salto Router Device and click Next.
5. Enter the Name of the router.
6. If available, select the Account Owner from the dropdown list.
7. Select the Control Panel the Salto Router will be linked to.
8. Enter the IP Address/MAC address for the Salto Router.
9. Enter the correct Service Port. This defaults to 1234.
10. If you wish to enable alarm console settings, check the "Combine Alarms"
checkbox. You may also provide instruction text, set alarm priority, schedule
when the alarm will function, and whether or not the alarms will function during
certain threat levels.
11. Click Save.
97
Page 97 of 334
Advertisement
Table of Contents
