Chamberlain IPAC Administrator's Manual page 151

IPAC Server Administrator's Manual
To configure Antipassback settings for a device:
NOTE:
All devices with readers can be configured for antipassback, and
alternate readers can be set up without antipassback enabled.

If device is using a device profile, the device follows the profile's
configured settings for antipassback.
If you are not planning on using the antipassback functionality of the
IPAC Server™ for a specific device, do not check the Enable checkbox
under Antipassback Settings during device creation.
1. Scroll over the Configuration section. The sub-navigation menu displays.
2. From the Devices link, click the Devices link. The Devices list page displays.
3. To apply Antipassback controls to a preexisting device, click on that device. The
Device Details page displays. (To configure the Antipassback controls for a new
device, see the section on Creating Devices.)
4. At the bottom of the Device Details page, click Edit. The Edit Device page displays.
5. To activate Antipassback, check the Enable box under the Antipassback Settings
heading.
6. The Antipassback controls are automatically configured for Hard Antipassback, with
the default reset interval set at 0 minutes. To configure Soft Antipassback, enter the
number of minutes from 1 to 999.
7. Select from the Primary Zone dropdown list which zone you would like to configure
Antipassback for use with your primary reader. Users start out in the (none) zone
when created.
8. Select from the Alternate Zone dropdown list which zone you would like to configure
Antipassback for use with your alternate reader, if one is configured. Users
presenting a credential at the primary reader will be transferred into this zone.
9. If you would like the door to be controlled by two readers, you may configure
Antipassback controls for an alternate reader by selecting a zone from the Alternate
Reader dropdown list.
10. Click Save. You are returned to the Device List page.
To configure Antipassback Settings for a group:
1. Scroll over the Users link. The sub-navigation menu displays.
2. From the sub-navigation menu, click the Group link. The group directory displays.
3. Click on the group for which you would like to configure Antipassaback. The group
details page displays.
4. Click Edit. The Edit Group page displays.
150
Page 150 of 334