Installation - Da-Lite Tensioned Large Cosmopolitan Electrol Instruction Book

INSTALLATION

Carefully unpack screen and remove outer wrapping from case.
The slat retainer screws must be removed before installation. The slotted 1/4" hex screws fasten through the back of the
case (at the bottom) into the slat bar. Orient the case with the slat down and then remove the screws. The case must
remain in that orientation throughout the installation process to avoid fabric damage.
The Tensioned Cosmopolitan
Procedures for each method are as follows:
Wall Mount
1. The wall mount bracket should be fastened to wall
studs or some reinforcement within the wall. Concrete
or brick walls require special fasteners and anchors.
2. The wall bracket has holes spaced at 16" and 24" to
align with most wall studs.
3. The bracket must be level and plumb.
4. keep in mind you will need at least 2-3/4" between the
ceiling and the top of the wall mount bracket to be
able to position the case on the bracket.
5. mount the screen case on the wall bracket as shown
in figure 1. be sure the case is fully seated on the
bracket. Tighten the stop screws against the wall
bracket.
Ceiling Mount
1. be sure the ceiling has adequate reinforcement to
attach the screen brackets.
2. attach the ceiling brackets to the wall mount bracket
using the supplied 5/16" x 3/4" bolts, washers and
nuts.
3. Position the ceiling bracket asssembly on the ceiling
and attach with 5/16" bolts (not supplied). The bolts
should be long enough to pass through the drywall or
ceiling tile and penetrate at least 1-1/2" into the
reinforcement in the ceiling.
4. mount the screen on the wall bracket as shown in
figure 2. be sure the case is fully seated on the
bracket. Tighten the stop screws against the wall
bracket.
Electrol comes with brackets to allow for wall mount or ceiling mount installations.
® ®
2"
CasE hOOk
Wall
mOunT
bRaCkET
sTOP sCREW
CasE hOOk
CEIlIng
mOunT
bRaCkET
5/16x3/4"
bOlT, nuT
and lOCk
WashER
Wall mOunT
bRaCkET
sTOP sCREW
2
vIEWIng suRfaCE
(audIEnCE sIdE)
FIGURE 1
1-1/8"
vIEWIng suRfaCE
(audIEnCE sIdE)
FIGURE 2