Important Safety Instructions; Pre-Installation - Da-Lite Tensioned Executive Electrol Instruction Book

IMPORTANT SAFETY INSTRUCTIONS

When using your video equipment, basic safety precautions should always be followed, in-
cluding the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at least equal to that of the
appliance should be used. Cords rated for less amperage than the appliance may over-
heat.
4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an autho-
rized service dealer when repair work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by the manufacturer may cause a
risk of fire, electric shock, or injury to persons.
SAVE THESE INSTRUCTIONS

PRE-INSTALLATION

1. Carefully unpack screen and remove outer wrapping from case.
2. Remove instructions cover and please read instructions. (Fig. 1)
3. Remove fabric and cardboard strips from access door. (Fig. 1)
4. Remove access door by gently prying from edge of box toward the fabric door.
5. FOR TYPE 3 INSTALLATION ONLY. Remove wood strips along bottom of screen case.
NOTE: Screen surface is not centered in box. Screen surface is 25" from motor end.
6. Make sure to recheck measurements of screen location before installation.
7. Remove, reverse, and remount center support brackets.
ACCESS DOOR
FABRIC DOOR
INSTRUCTION COVER
FIGURE 1
INSTALLATION
1. Position screen under mounting location with the case opening down.
2. Install screen by raising unit into position between joists at one end only. Install one lag screw in each mounting
bracket. Secure opposite end. Support center of the screen using the brackets.
3. Level unit lengthwise with a carpenter's level and a plum level.
▲
CAUTION! Do not secure access door or seal in unit until screen has been secured in position and properly tested for satisfac-
!
tory operation. Do not fit unit so tightly that the screen surface drop door binds. Door drops by gravity only.
CASE
FABRIC
STRIP
CARDBOARD
STRIP
1