Da-Lite Tensioned Advantage Electrol Instruction Book
Hide thumbs
Also See for Tensioned Advantage Electrol:
- Instruction book (12 pages) ,
- Installer's manual (2 pages) ,
- Instruction book (8 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Da-Lite Tensioned Advantage Electrol
Summary of Contents for Da-Lite Tensioned Advantage Electrol
- Page 1 INSTRUCTION BOOK FOR Tensioned Advantage Electrol ® ®...
-
Page 2: Important Safety Instructions
If your case was ordered in advance of the screen and roller assembly, your installation is now complete. Continue to step 4 if your Tensioned Advantage Electrol was ordered as a complete unit. 4. Use supplied 1/8" hex key to remove silver shipping brackets attached to slat and screen case. - Page 3 Screen And Roller Assembly Installation Tools required for screen and roller assembly: #2 Phillips Screwdriver 1/8“ Hex Key 1/2“ Open Wrench 1/4“ Open Wrench or Socket Driver or Socket Driver Follow these steps if your screen and roller assembly was ordered separately from the case. Remove the access door.
- Page 4 Tensioned Advantage Electrol Suggested Methods of Installation ® ® Method 1 6 1/16" 6 7/16" 7 3/4" Variable Position Mounting Bracket 8" Audience Side Motor 6 1/16" 3/8" Threaded Rod (Not Included) Electrical Attached To Junction Box Mounting Bracket 6 3/8" Self-Trimming Finished Flange...
- Page 5 Screen Adjustment for 120V Screens If your Tensioned Advantage Electrol was ordered as a complete unit, the up and down limits were pre-set by Da-Lite. If your screen and roller assembly was ordered separately from the case, or if general adjustment is needed, please follow the steps below and refer to the 120V Wiring Diagram.
- Page 6 Tensioned Advantage Electrol Installation for 120V Screens ® ® 120V Wiring Diagram 3-conductor 20–24 gauge wire can be used in place of the IMPORTANT NOTE: The wall switch is REQUIRED to make any S T O supplied RJ-14 cable to connect the wall switch. Connect the BUS limit switch adjustments, EVEN if a third party control system is terminals on the wall switch to the corresponding BUS terminals used.
- Page 7 Tensioned Advantage Electrol Installation for 120V Screens ® ® 120V Wiring Diagram with Optional Built-In Video Projector Interface CAUTION: The projector must be turned off before connecting IMPORTANT NOTE: The wall switch is REQUIRED to make any the trigger wires to the projector. Failure to do so may damage limit switch adjustments, EVEN if a third party control system is the controller.
- Page 8 Tensioned Advantage Electrol Installation for 220/240V Screens ® ® 240V Wiring Diagram ILT RJ-9 Pin-Outs (Tab Is Facing Up) IMPORTANT NOTE: The wall switch is REQUIRED to make any IR or Up Black limit switch adjustments, EVEN if a third party control system is Ground Common used.
-
Page 9: Troubleshooting
Troubleshooting Visit www.da-lite.com/products/tutorials.php to find installation You can contact us by email at info@da-lite.com or by phone at and troubleshooting tutorials. You will also find a link to Live 800.622.3737 or 574.267.8101 with any additional troubleshooting Chat for interactive support. - Page 12 OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137, Warsaw, IN 46581-0137, (574) 267-8101, (800) 622-3737.