Table of Contents
Advertisement
When using your video equipment, basic safety precautions should always be followed, including the
following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance
should be used. Cords rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized
service dealer when repair work is required. Incorrect reassembly can cause electric shock when
the appliance is used subsequently.
5. The use of an accessory attachment not recommended by the manufacturer may cause a risk of
fire, electric shock, or injury to persons.
PRE-INSTALLATION
1. Carefully unpack screen and remove outer wrapping from case.
2. Make sure to recheck measurements of screen location before installation.
INSTALLATION
1. Install screen by raising unit into position between joists at one end only. Install lag screws in mounting bracket or
hang from 3/8" rods.
2. Level unit lengthwise with a carpenter's level and plumb level. Secure opposite end.
▲
!
CAUTION! Do not secure access door or seal in until screen has been secured in position and properly tested for satisfactory
operation.
3. Remove screw at each end of roller access door (Fig. 1).
4. Remove junction box cover plate.
If your screen has the built in SCB-100 or SCB-200, please refer to separate instructions.
5. Install electric hook up that applies to your unit. Make sure to review your electrical installation checklist and wiring
diagram (included) for either 120 volt switch, 220/240 volt switch, or DRC low voltage control.
NOTE: Screen has been internally wired at Da-Lite. Wiring designated "external" is completed by installer conforming to local
and national codes.
▲
!
CAUTION! DO NOT CUT TAPE ON FABRIC WITH A KNIFE OR ANY SHARP TOOL. REMOVE BY HAND.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
SCREW FOR
SECURING ROLLER
ACCESS DOOR
FABRIC DOOR
1
ACCESS
DOOR
FIGURE 1
Advertisement
Table of Contents
