Important Safety Instructions; Pre-Installation - Da-Lite EXECUTIVE ELECTROL Instruction Book

Hide thumbs Also See for EXECUTIVE ELECTROL:

Specification (2 pages)

Instruction book (8 pages)

Instruction book (12 pages)

Table of Contents

When using your video equipment, basic safety precautions should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be

used. Cords rated for less amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not disassemble this appliance. Contact an authorized service dealer

when repair work is required. Incorrect reassembly can cause electric shock when the appliance is used subse-

quently.

5. The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric

shock, or injury to persons.

PRE-INSTALLATION

1. Carefully unpack screen and remove outer wrapping from case.

2. Remove fabric and cardboard strips from access door.

3. Remove access door by gently prying from middle section.

4. FOR TYPE 3 INSTALLATION ONLY, remove wood strips along bottom edge of screen case.

5. Remove instruction cover (Fig. 1). Remove, reverse, and remount Center Support Brackets.

6. Do not remove metal shipping brace (secures roller), wrapping paper or tape until screen is installed.

NOTE: Screen is not centered in box. Screen is set 22" from motor end.

7. Make sure to recheck measurement of screen location before installation.

CASE

ACCESS DOOR

FABRIC DOOR

INSTRUCTION COVER

FIG.1

INSTALLATION

1. Install screen by raising unit into position between joists at one end only. Install one lag screw in each mounting

bracket. Secure opposite end. Support center of the screw using the brackets.

2. Level unit lengthwise with a carpenter's level and a plum level.

▲

CAUTION! DO NOT SECURE ACCESS DOOR OR SEAL IN UNIT UNTIL SCREEN HAS BEEN SECURED IN POSITION AND PROP-

ERLY TESTED FOR SATISFACTORY OPERATION. DO NOT FIT UNIT SO TIGHTLY THAT THE SCREEN SURFACE DROP DOOR BINDS.

DOOR DROPS BY GRAVITY ONLY.

3. If you are going to cover screen door with paneling or other materials, allow access (suitable holes or a plug) to

screws when servicing.

4. Remove shipping brace by removing 3 hex head screws (Fig. 2).

▲

CAUTION! DO NOT CUT WRAPPING PAPER OR TAPE WITH KNIFE OR ANY SHARP TOOL. REMOVE BY HAND.

5. Remove tape strips and release fabric (Fig. 2). Picture surface should hang freely (Fig. 3). Remove any tape left

hanging on back of fabric. Bottom edge should be positioned between bottom edge of case and center of roller.