Download
Share
Print this page
Da-Lite TENSIONED LARGE COSMOPOLITAN ELECTROL Instruction Book
  1. Manuals
  2. Brands
  3. Da-Lite Manuals
  4. Projection Screen
  5. TENSIONED LARGE COSMOPOLITAN ELECTROL
  6. Instruction book

Da-Lite TENSIONED LARGE COSMOPOLITAN ELECTROL Instruction Book

9'x12', 180" diagonal and larger sizes
Hide thumbs Also See for TENSIONED LARGE COSMOPOLITAN ELECTROL:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
The Da-Lite Difference.
Instruction Book for
tensIoned LARGe CosMoPoLItAn®
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
Post Office Box 137
eLeCtRoL®
Warsaw, Indiana 46581-0137
Phone: 574-267-8101
9'x12' , 180" diagonal and Larger sizes
800-622-3737
Fax: 574-267-7804
www.da-lite.com
e-mail: info@da-lite.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the TENSIONED LARGE COSMOPOLITAN ELECTROL and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Da-Lite TENSIONED LARGE COSMOPOLITAN ELECTROL

Summary of Contents for Da-Lite TENSIONED LARGE COSMOPOLITAN ELECTROL

  • Page 1 The Da-Lite Difference. Instruction Book for tensIoned LARGe CosMoPoLItAn® DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street Post Office Box 137 eLeCtRoL® Warsaw, Indiana 46581-0137 Phone: 574-267-8101 9'x12' , 180" diagonal and Larger sizes 800-622-3737 Fax: 574-267-7804 www.da-lite.com e-mail: info@da-lite.com...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces.

  • Page 3: Installation

    INSTALLATION Carefully unpack screen and remove outer wrapping from case. The slat retainer screws must be removed before installation. The slotted 1/4" hex screws fasten through the back of the case (at the bottom) into the slat bar. Orient the case with the slat down and then remove the screws. The case must remain in that orientation throughout the installation process to avoid fabric damage.
  • Page 4 In lEfT mOTOR EndCaP gREEn 240 VOLT WIRING DIAGRAM FOR STANDARD WALL SWITCH: da-lite offers two styles of 240 volt wall switches for standard operation. Please see wiring diagram in wall switch boxes included with screen. sPdT sWITCh WITh aC (COmmOn)
  • Page 5 SCREEN ADjUSTMENT FOR SCREENS WITHOUT A BUILT-IN LOW VOLTAGE CONTROL SETTING THE UP LIMIT POSITION CAUTION: Do not allow the slat bar to wrap over the top of the roller when the screen is rolling into the case. The screen could be damaged.
  • Page 6 TENSIONED COSMOPOLITAN ELECTROL INSTALLATION FOR SCREENS WITH A BUILT-IN LOW VOLTAGE ® ® CONTROL 240V WIRING DIAGRAM WITH OPTIONAL BUILT-IN OPTIONAL IR AND RF REMOTE CONTROL LOW VOLTAGE CONTROL LOW-VOLTAGE WALL SWITCH UP DN GND +5V BLUE (COMMON) BROWN (HOT) MOTOR 240VAC 50HZ STOP...
  • Page 7 TROUBLESHOOTING SYMPTOM CAUSE SOLUTION 1. screen will not operate. (a) blown fuse. (a) Replace fuse. motor does not hum. (b) Tripped circuit breaker. (b) Reset circuit breaker. (c) no power to operating switch (c) Check above. Tighten all loose or junction. wire connections.
  • Page 8 EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a da-lite product, you may contact our sales Partners at PO box 137 , Warsaw, In 46581-0137 , (574) 267-8101, (800) 622-3737 .