Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 72

Using the panic alarm
If you are near your vehicle and feel threat-
ened, you may acti-vate the alarm to call
attention as follows:
1. Press the PANIC button (3) for more than
1 second.
2. The headlights will blink on and off and
the horn will sound intermittently for
about 3 minutes.
3. To turn off the alarm, press any button on
the remote control transmitter.
Replacement remote control
transmitters
Only remote control transmitters
grammed with the vehicle's electronics can
lock or unlock all doors and the liftgate.
If you lose the remote control transmitter, you
can order a remote control transmitter from
your authorized Mitsubishi Motors dealer by
referring to the key number.
To prevent vehicle theft, the ID code for the
remote control transmitter must be changed.
Take your vehicle and all remote control
transmitters to your authorized Mitsubishi
Motors dealer to have your ID code changed.
Additional remote control
transmitters
N00543700034
To add a remote control transmitter, you must
already have 1 registered remote control
transmitter.
Registering the ID code can be done by your-
self or by your authorized Mitsubishi Motors
dealer. For you to register the ID code your-
self, follow the "Customer remote control
transmitter programming" procedure below.
If you choose to have your authorized
Mitsubishi Motors dealer register the ID
code, take your vehicle and any remaining
keys to your authorized Mitsubishi Motors
dealer.
N00543800051
NOTE
pro-
 You are provided with 2 remote control
transmitters, but you may register up to 8
remote control transmitters.
Customer remote control trans-
mitter programming
You can program new remote control trans-
mitters to the system if you have one valid
(already registered) remote control transmit-
ter by doing the following:
I n f o r ma t i o n P r o v i d e d b y :
Keyless entry system (if so equipped)
1. Have available all (current and new)
remote control transmitters you wish to
register.
2. With a valid (already registered) remote
N00543900049
control transmitter, press and hold the
UNLOCK button (2) for 4 to 10 seconds.
Then press and hold the LOCK button (1)
during this time.
3. Within 10 seconds of pressing the LOCK
button, release the LOCK button first, and
then release the UNLOCK button.
At this time, ID codes for all remote con-
trol transmitters except for the transmitter
used in steps 2 and 3 are erased and the
answerback function (door is locked and
unlocked) informs you that the registra-
tion mode has been activated.
4. Within 60 seconds after step 3, complete
the following ID code registration opera-
tion using the next remote control trans-
mitter you wish to register within 4
seconds.
i) Press and hold both the LOCK and
UNLOCK buttons for 2 seconds.
ii) Release both the LOCK and UNLOCK
buttons simultaneously for 1 second.
iii) Press the UNLOCK button. The
answerback function informs you that the
N00544001116
ID code registration of the transmitter is
completed.
Features and controls
5
5-9