Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 359

Replacement of light bulbs
2. Turn the socket and bulb assembly coun-
terclockwise to remove it.
B- Rear side-marker light, and tail and stop
light (LED)
9
- cannot be replaced
C- Rear turn signal light
NOTE
 The rear side-marker light, and the tail and
stop light uses an LED instead of the bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
9-36 Vehicle care and maintenance
3. Pull the bulb out of the socket.
4. To install the bulb, perform the removal
steps in reverse.
NOTE
 When mounting the light unit, align the
groove (D) on the light unit with the clip on
the body and the pin (E) on the unit with the
hole in the body.
I n f o r ma t i o n P r o v i d e d b y :
Back-up lights
1. Open the liftgate.
2. Insert a screwdriver into the notch of the
cover and pry gently to remove the cover.
NOTE
 Wrap a cloth around the tip of the screw-
driver to keep from scratching the cover.
N00929101077