Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 204

4. The voice guide will say "This operation
must be performed in a quiet environment
while the vehicle is stopped. See the
owner's manual for the list of required
training phrases. Press and release the
SPEECH button when you are ready to
begin. Press the HANG-UP button to can-
cel at any time."
Press the SPEECH button to start the
speaker enrollment process.
NOTE
 If you do not start the speaker enrollment
process within 3 minutes after pressing the
SPEECH button, the speaker enrollment
function will time out.
The voice guide will say "Speaker enroll-
ment has timed out." The system will then
beep and the voice recognition mode will be
deactivated.
5. The voice guide will prompt for phrase 1.
Repeat the corresponding phrase listed in
table "Enrollment commands" on page
5-157.
The system will register your voice and
then move on to the registration of the
next command. Continue the process until
all phrases have been registered.
NOTE
 To repeat the most recent voice training com-
mand, press and release the SPEECH button.
 If you press the HANG-UP button anytime
during the process, the system will beep and
stop the speaker enrollment process.
6. When all enrollment commands have
been read out, the voice guide will say
"Speaker enrollment is complete." The
system will then end the speaker enroll-
ment process and return to the main
menu.
NOTE
 Completing the speaker enrollment process
will turn on the voice model automatically.
 The commands "Help" and "Cancel" will not
work in this mode.
I n f o r ma t i o n P r o v i d e d b y :
Bluetooth® 2.0 interface (if so equipped)
Enabling and disabling the voice
model and retraining
You can turn a voice model registered with
the speaker enrollment function on and off
whenever you want.
You can also retrain the system.
Use the following procedure to perform these
actions.
1. Press the SPEECH button (except for
vehicles with Mitsubishi Multi-Commu-
nication System) or PICK-UP button (for
vehicles with Mitsubishi Multi-Commu-
nication System).
2. Say "Voice training."
3. If you have completed a speaker enroll-
ment process once already, the voice
guide will say either "Enrollment is
enabled. Would you like to disable or
retrain?" or "Enrollment is disabled.
Would you like to enable or retrain?"
4. When enrollment is "enabled," the voice
model is on; when enrollment is "dis-
abled," the voice model is off. Say the
command that fits your needs.
Say "Retrain" to start the speaker enroll-
ment process and recreate a new voice
model. (Refer to "Speaker enrollment" on
page 5-140.)
Features and controls
N00564901081
5
5-141