Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 181

Warning lights
NOTE
 If the indicator flashes faster than usual or if
the indicator stays on without flashing, check
for a malfunctioning turn signal light bulb or
turn signal connection.
5
High beam indicator
A blue light comes on when the headlights
are on high beam.
Front fog light indicator
equipped)
This indicator comes on while the front fog
lights are on.
Position indicator
This indicator light illuminates while the
position lights are on.
ECO mode indicator
equipped)
This indicator will be displayed when fuel-
efficient driving is achieved.
5-118 Features and controls
Warning lights
Brake warning light
This light comes on when the ignition switch
is turned to the "ON" position (engine off) or
the operation mode is put in ON.
N00520100086
When the engine is started, the light should
go off a few seconds later. A warning is also
displayed in the multi-information display.
The warning light also illuminates after start-
(if so ing the engine under the following condi-
tions.
N00520200175
 When the parking brake is still applied.
 When the brake fluid level is low.
 When the brake system circuit is not
working properly.
Before driving, be sure that the parking brake
is fully released and brake warning light is
N00551300026
off.
CAUTION
(if so  If the brake warning light and the Anti-lock
braking system warning light are illuminated
at the same time, the braking force distribu-
N00568800023 tion function will not operate, so the vehicle
may be destabilized during sudden braking
under the following conditions.
N00520300147
N00520400470
I n f o r ma t i o n P r o v i d e d b y :
CAUTION
• When the brake warning light does not go
out even when the parking brake is
released.
• When the brake warning light stays on
while driving.
• If the above occurs, avoid sudden braking
and high-speed driving. Park the vehicle in
a safe place, and contact an authorized
Mitsubishi Motors dealer or a repair facility
of your choice as soon as possible.
 The vehicle should be brought to a halt in the
following manner when brake performance
is deteriorated.
• Confirm that the vehicle slows down when
you press down on the brake pedal harder
than usual. In some cases, the brake pedal
may go all the way to the floor.
• Should the brakes fail, use engine braking
to reduce your speed and slowly apply the
parking brake.
Depress the brake pedal to illuminate the
stop lights to alert the vehicles behind you.
Engine malfunction indicator
("SERVICE ENGINE SOON"
or "Check engine light")
This indicator is a part of the onboard diag-
nostic (OBD) system which monitors the
emissions, engine control system or continu-
ously variable transmission (CVT) control
N00520500804