Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 189

Combination headlights and dimmer switch
5
NOTE
 While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK button (B) on the remote
control transmitter.
• Turn the combination headlights and dim-
mer switch to the "
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The headlights can be set to come on in the
low beam setting.
5-126 Features and controls
NOTE
• The welcome light function can be deacti-
vated.
For details, consult a Mitsubishi Motors
dealer.
Coming home light
This function turns on the headlights in the
low beam setting for about 30 seconds after
the ignition switch is turned to the "OFF"
position or the operation mode is put in OFF.
1. Turn the combination headlights and dim-
mer switch to the "OFF" or "AUTO"
position (for vehicles equipped with the
automatic light control).
2. Turn the ignition switch to the "OFF"
position or put the operation mode in
OFF. Also, if a key was used to start the
engine, remove the key from the ignition
switch.
" or " " position.
N00547301123
I n f o r ma t i o n P r o v i d e d b y :
3. Within 60 seconds of turning the ignition
switch to the "OFF" position or putting
the operation mode in OFF, pull the turn
signal lever toward you.
4. The headlights will come on in the low
beam setting for about 30 seconds. After
the headlights go off, the headlights can
be turned on again in the low beam setting
for about 30 seconds by pulling the turn
signal lever toward you within 60 seconds
of turning the ignition switch to the
"OFF" position or putting the operation
mode in OFF. To turn on the headlights
again after 60 seconds of turning the igni-
tion switch to the "OFF" position or put-
ting the operation mode in OFF, repeat the
process from step 1.