Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 270

NOTE
 Sometimes, for example after using a high-
pressure car wash, the condenser can get wet,
and the air conditioning indicator light (A)
blinks temporarily. Wait for a while, press
the air conditioning switch once to turn the
system off, then once more to turn it back on.
Once the water evaporates, the blinking will
stop.
Personalizing the air conditioning
switch (Changing the function set-
ting)
You can change the following functions to
match your preference.
 Enable automatic air conditioning control:
When the mode selection dial or blower
speed selection dial has been set to the
"AUTO" position or when the tempera-
ture control dial has been set to the mini-
mum temperature, the air conditioning
switch is automatically controlled.
 Disable automatic air conditioning con-
trol:
The air conditioning switch is not auto-
matically controlled, unless the air condi-
tioning switch is used.
 Changing the settings
Press the air conditioning switch for about
10 seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled,
the system will beep three times and the
indicator will flash three times.
• When the setting has changed from dis-
abled to enabled,
the system will beep two times and the
indicator light will flash three times.
N00759800029
NOTE
 The factory setting is "Enable automatic air
conditioning control".
 While the mode selection dial is set to the
" " position, the air conditioning will run
automatically, even if the system is set to
"Disable automatic air conditioning control",
in order to prevent windows from fogging
up.
I n f o r ma t i o n P r o v i d e d b y :
Automatic air conditioning-Type2 (if so equipped)
Operating the air conditioning
system (automatic mode)
In normal conditions, use the system in the
AUTO mode and follow these procedures:
1. Set the blower speed selection dial to the
"AUTO" position.
2. Select the temperature control dial to the
desired temperature. The temperature can
be set within a range of around 18 to 32.
The temperature will increase as the dial
is turned to the right.
3. Set the mode selection dial to the
"AUTO" position.
The vents (except "
side air, blower speed, and ON/OFF of air
conditioning will be controlled automatically.
Comfort controls
N00731700286
7
"), recirculation/out-
7-23