Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 69

Electronic immobilizer (Anti-theft starting system)
Customer key programming
(Except for vehicles sold in
Canada)
You can program new keys to the system if
you have two valid (already registered) keys
5
and blank immobilizer key (specially cut for
your vehicle at your Mitsubishi Motors
dealer) by doing the following:
1. Insert the first valid key into the ignition
switch and turn the key to the "ON" posi-
tion for 5 seconds.
2. Turn the key to the "OFF" position and
remove the first key.
3. Within 30 seconds of removing the first
key, insert the second valid key into the
ignition and turn it to the "ON" position.
About 10 seconds later, the immobilizer
display will start to blink.
5-6 Features and controls
4. When the immobilizer display starts
blinking, turn the second valid key to the
"OFF" position and remove it. Within 30
seconds after doing so, insert a blank
immobilizer key into the ignition switch
N00562200126
and turn it to the "ON" position. Perform
this operation no more than 30 seconds
after the immobilizer display starts blink-
ing. When registration of the ID code is
complete, the immobilizer display will
come on for 3 seconds then go off. If an
error occurs, the immobilizer display will
go off during the procedure.
NOTE
 When the key registration is completed, the
immobilizer display will come on within 30
seconds of turning the ignition switch to the
"ON" position with the blank immobilizer
key (specially cut for your vehicle at your
Mitsubishi Motors dealer).
5. If you wish to register another key, per-
form the process again from step 1.
I n f o r ma t i o n P r o v i d e d b y :
NOTE
 Perform the operation when the interrupt dis-
play screen is not showing. The interrupt dis-
play screen may prevent you from seeing the
immobilizer display.
 It is not possible to register a key if:
• the immobilizer display goes off during the
procedure
• the immobilizer display does not come on
within 30 seconds after step 4.
 The procedure will be terminated automati-
cally if:
• a period of 30 seconds or longer elapses
from the moment when the first key is
turned to the "OFF" position to the moment
when the second key is turned to the "ON"
position
• a period of 30 seconds or longer elapses
from the moment when the second key is
turned to the "OFF" position to the moment
when the blank immobilizer key is turned
to the "ON" position
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to "Keyless entry system: Cus-
tomer remote control transmitter program-
ming" on page 5-9.