Mitsubishi 2015 OUTLANDER SPORT/RVR Owner's Manual page 219

Bluetooth® 2.0 interface (if so equipped)
5. The voice guide will say "Importing the
contact list from the mobile phonebook.
This may take several minutes to com-
plete. Would you like to continue?"
Answer "Yes," transferring to the mobile
phonebook the phonebook stored in the
cellular phone will start.
Answer "No," the system will return to
5
the main menu.
NOTE
 The transfer may take some time to complete
depending on the number of contacts.
®
 If the Bluetooth 2.0 interface could not be
connected to the Bluetooth
lular phone, the voice guide will say "Unable
to transfer contact list from phone" and then
the system will return to the main menu.
 If you press the HANG-UP button or press
and hold the SPEECH button during the data
transfer, the transfer will be cancelled and
the system will return to the main menu.
 If an error occurs during the data transfer, all
transfers will be cancelled and the voice
guide will say "Unable to complete the
phonebook import" and then the system will
return to the main menu.
 If there are no contacts in the phonebook, the
voice guide will say "There are no contacts
on the connected phone."
5-156 Features and controls
6. When the transfer is complete, the voice
guide will say "Import complete" and
then the system will return to the main
menu.
General information
MODEL: MMC FCC ID: CB2MDGMY10
IC: 279B-MDGMY10
Your Bluetooth
radio frequency subject to Federal Communi-
cations Commission (FCC) Rules (For vehi-
cles sold in U.S.A.) and Industry Canada
Rules (For vehicles sold in Canada). This
®
compatible cel-
device complies with Part 15 of the FCC
Rules and RSS-210 of the Industry Canada
Rules. Operation is subject to the following
two conditions:
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
CAUTION
 Changes or modifications made to this
equipment not expressly approved by the
manufacturer may void the FCC authoriza-
tion to operate this equipment.
N00566301089
®
2.0 interface operates on a
I n f o r ma t i o n P r o v i d e d b y :
The term "IC:" before the radio certification
number only signifies that Industry Canada
technical specifications were met.
The antenna used for this transmitter must not
be co-located or operating in conjunction
with any other antenna or transmitter. End-
users and installers must be provided with
installation instructions and transmitter oper-
ating conditions for satisfying RF exposure
compliance.
FCC Notice: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radi-
ate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which
can be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the
equipment and receiver.