Setting Strong Security Mode - Cisco TelePresence System Codec C40 Administrator's Manual

Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Contents

Setting strong security mode

Strong security mode should be used only when compliance
with DoD JITC regulations is required.
Read the warning carefully before setting strong
security mode.
Strong security mode sets very strict password requirements,
and requires all users to change their password on the next
sign in.
Software upload from TMS, web snapshots and calling from
the web interface are prohibited in strong security mode.
D14636.10 Profile C60-C40 and Codec C60-C40
Introduction Web interface Web interface
Navigate to: Configuration > Security
Setting strong security mode
1. Click
and read the warning carefully before
continuing.
2. If you want to use strong security
mode, check the
of strong security mode
click Enable strong security
3. Change the password to meet the
strict criteria shown in the warning.
How to change the system password:
see the
4. Restart the codec for the change to
take effect.
Administrator Guide TC6.1, APRIL 2013.
System settings
Configure strong security mode...
I understand the risks
check box and
mode.
► Setting passwords section.
43
Setting passwords
Return to normal mode
1. When in strong security mode,
the system can be restored
to normal mode by clicking
Configure strong security mode...
followed by Disable strong
security mode.
2. Restart the codec for the change
to take effect.
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices