Cisco TelePresence System Codec C40 Administrator's Manual page 63

Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Contents
Cameras Camera [1..7] DHCP
Applies to cameras which support DHCP (for example the Cisco TelePresence PrecisionHD
1080p 12X camera). The camera must be connected to a LAN. When set, the command
enables support for SW upgrade of daisy chained cameras. It will enable the camera's DHCP
function and force start of MAC and IP address retrieval. Remember to reset the DHCP when
the camera is no longer connected to a LAN.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable DHCP in the camera. NOTE: This setting should be applied when the camera is
not connected to a LAN.
On: Enable DHCP in the camera. The camera is automatically re-booted. After re-boot the
DHCP is started and the IP address will be retrieved. Run the commnand "xStatus Camera"
for result.
Cameras Camera 1 DHCP: Off
Example:
D14636.10 Profile C60-C40 and Codec C60-C40
Introduction Web interface
Administrator Guide TC6.1, APRIL 2013.
System settings System settings
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
63
Administrator Guide
Setting passwords Appendices