Setting Strong Security Mode - Cisco C20 TelePresence System Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents

Setting strong security mode

Strong security mode should be used only when compliance
with DoD JITC regulations is required.
Read the warning carefully before setting strong
security mode.
Strong security mode sets very strict password requirements,
and requires all users to change their password on the next
sign in.
Software upload from TMS, web snapshots and calling from
the web interface are prohibited in strong security mode.
D14637.10 Profile C20 and Quick Set C20 Administrator Guide TC6.1, APRIL 2013.
Introduction Web interface Web interface
Navigate to: Configuration > Security
Setting strong security mode
1. Click Configure strong security mode...
and read the warning carefully before
continuing.
2. If you want to use strong security
mode, check the
of strong security mode
click Enable strong security
3. Change the password to meet the
strict criteria shown in the warning.
How to change the system password:
see the ► Setting passwords
4. Restart the codec for the change to
take effect.
System settings
I understand the risks
check box and
Return to normal mode
mode.
1. When in strong security mode,
the system can be restored
to normal mode by clicking
Configure strong security mode...
section.
followed by
security
2. Restart the codec for the change
to take effect.
39
Setting passwords
Disable strong
mode.
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices