Setting Strong Security Mode - Cisco TelePresence System Codec C40 Administrator's Manual

Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Contents

Setting strong security mode

Strong security mode should be used only when compliance
with DoD JITC regulations is required.
Read the provided information carefully before setting
strong security mode.
Strong security mode sets very strict password requirements,
and requires all users to change their password on the next
sign in.
Software upload from TMS, web snapshots and calling from
the web interface are prohibited in strong security mode.
D14636.13 Profile C60-C40 and Codec C60-C40 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface Web interface
Navigate to: Configuration > Security: Strong Security Mode tab
System settings
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
46
Administrator Guide
Setting passwords Appendices
Setting strong security mode
Read carefully about the consequences of
strong security mode before you continue.
1. If you want to use strong security mode,
click Enable strong security
Confirm your choice in the dialog box that
The system will restart automatically.
2. Change the password when you are
prompted. The new password must meet
the strict criteria as described.
How to change the system password is
described in the ► Setting passwords
Return to normal mode
1. When in strong security mode, the system
can be restored to normal mode by
clicking Disable strong security
2. The system will restart automatically.
mode.
appears.
section.
mode....