Setting Strong Security Mode - Cisco TelePresence MX200 Administrator's Manual

Cisco TelePresence MX200 and MX300
Contents

Setting strong security mode

Strong security mode should be used only when compliance
with DoD JITC regulations is required.
Read the provided information carefully before setting
strong security mode.
Strong security mode sets very strict password requirements,
and requires all users to change their password on the next
sign in.
D14850.12 MX200 and MX300 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface Web interface
Navigate to: Configuration > Security: Strong Security Mode tab
System settings
www.cisco.com — Copyright © 2011–2015 Cisco Systems, Inc. All rights reserved.
40
Administrator Guide
Setting passwords Appendices
Setting strong security mode
Read carefully about the consequences of
strong security mode before you continue.
1. If you want to use strong security mode,
click Enable strong security
Confirm your choice in the dialog box
The system will restart automatically.
2. Change the password when you are
prompted. The new password must meet
the strict criteria as described.
How to change the system password is
described in the ► Setting passwords
Return to normal mode
When in strong security mode, the system
can be restored to normal mode by clicking
Disable strong security mode.... Confirm your
choice in the dialog box that appears
The system will restart automatically.
mode....
that appears.
section.