Cisco TelePresence System Codec C40 Administrator's Manual page 111

Cisco TelePresence System Codec C40/C60 and Profiles using C40/60
Contents
Video OSD AutoSelectPresentationSource
Determine if the presentation source should be automatically selected.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable automatic selection of the presentation source.
On: Enable automatic selection of the presentation source.
Video OSD AutoSelectPresentationSource: Off
Example:
Video OSD TodaysBookings
This setting can be used to display the system's bookings for today on the main OSD
menu. This requires that the system is bookable by an external booking system, like Cisco
TelePresence Management Suite (TMS).
Requires user role: ADMIN
Value space: <Off/On>
Off: Do not display todays bookings.
On: Displays information about this systems bookings on screen.
Video OSD TodaysBookings: Off
Example:
Video OSD MyContactsExpanded
Set how the local contacts will be displayed in the phone book dialog in the OSD (On Screen
Display).
Requires user role: ADMIN
Value space: <Off/On>
Off: The local contacts will be placed in a separate folder called MyContacts in the
phonebook dialog.
On: The local contacts in the phone book will be shown in the top level of the phonebook
dialog.
Video OSD MyContactsExpanded: Off
Example:
D14636.10 Profile C60-C40 and Codec C60-C40
Introduction Web interface
Administrator Guide TC6.1, APRIL 2013.
System settings System settings
Video OSD Output
The Video OSD (On Screen Display) Output lets you define which monitor should display the on
screen menus, information and icons. By default the OSD is sent to the monitor connected to
the Video OSD Output 1. If you cannot see the OSD on screen, then you must re-configure the
OSD Output. You can do this by entering a key sequence on the remote control, from the web
interface, or by a command line interface.
Using the remote control: Press the Disconnect key followed by: * # * # 0 x # (where x is output
1 to 2).
Using the web interface: Open a web browser and enter the IP address of the codec. Open the
Advanced Configuration menu and navigate to Video OSD Output and select the video output.
Using a command line interface: Open a command line interface and connect to the codec (if in
doubt of how to do this, see the API Guide for the codec). Enter the command: xConfiguration
Video OSD Output [1..2] (select the OSD Output)
Requires user role: ADMIN
Value space: <1/2>
Range: Select 1 for HDMI 1 output, or select 2 for DVI-I 2 output.
Video OSD Output: 1
Example:
Video OSD InputMethod InputLanguage
The codec can be enabled for Cyrillic input characters in the menus on screen. NOTE: Requires
that xConfiguration Video OSD inputMethod Cyrillic is set to On.
Requires user role: ADMIN
Value space: <Latin/Cyrillic>
Latin: Latin characters can be entered when using the remote control (default).
Cyrillic: Cyrillic characters can be entered using the remote control. NOTE: Requires a Cisco
TelePresence Remote Control with Cyrillic fonts.
Video OSD InputMethod InputLanguage: Latin
Example:
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
111
Administrator Guide
Setting passwords Appendices