Device; General - Nuvico EV2-400 Instruction Manual

7. DEVICE

7.1. GENERAL

This DVR support 1 Audio, Alarm input and 1 relay output1 and support HDMI output.
1. The menus are displayed with options on the left-hand column and settings in the right
hand column. A cursor (highlighted menu) can be moved using the Direction buttons
[ ].
1) DISPLAY : Please decide to Output resolution
It automatically detects and set correct video resolution on the monitor in default.
[800*600
HDMI AUTO
Automatically detects and sets the HDMI resolution on the monitor connected to the
DVR. It might display "no video" if a VGA monitor is not able to support high
resolution.
In order to connect HDMI and VGA output to use both monitors, please set up as the
<NOTE>
lowest resolution without selecting HDMI AUTO.
2) Audio Map: Select audio recording device usage 1~4.
3) The audio data is always recorded in real time unlike the video data that can be
recorded in various modes including real time.
synchronization of the audio to video
4) Keypad Model: Select Joystick Controller and Baud Rate.
5) Extend Device: Future use.
6) PTZ Event: DURATION [OFF,1SEC ~ 5 SEC] : Select PTZ EVENT duration.
7) Alarm out: DURATION [OFF,1SEC ~ 5 SEC] : Select Alarm duration.
2. Select SAVE to save changes and press [ENTER] button to exit the menu.
Exit the menu without making changes, press [CANCEL] button.
1024*768 1280*720 1280*1024 1920*1080P]
There may be a slight delay in
55 EV2 Series DVR