Time - Nuvico EV2-400 Instruction Manual

8.2. TIME

Make sure to set up your Date and Time prior to start Recording.
1. Use Left/Right buttons [
with options on the left-hand column and settings in the right hand column. A cursor
(highlighted menu) can be moved using the Direction buttons [
button to change the values.
1) Time Zone: Refer to <Appendix 1: Time Zone Chart>
Selects the time zone in which the DVR is located. Time Zone contains DST
(Daylight Saving Time) On. If you choose Time Zone with DST, there is no change in
the system time stamp for recorded data. When the Daylight saving End date and
time occur, the DVR's time goes back one hour.
2) Date Format: Select Date display format.
[MM/DD/YYYY
3) NTP SYNC: The internal time of DVR can be synchronized with an external time
source using NTP (Network Time Server) Configuration. If the NTP option is ON, the
DATE and Time option is inactivated.
4) NTP Server: Allow you to use a public or private NTP server. Enter the IP address of
sever or domain. The default setting is public "pool.ntp.org".
<Note> Time Sync. Interval: Min 64 sec. Max 1024 sec.
5) NTP TEST: Test whether NTP Server works or fail.
6) Date & Time: Set current time and date.
2. Select SAVE to save changes and press [ENTER] button to exit the menu.
Exit the menu without making changes, press [CANCEL] button.
] to select on TAP menu "Time". The menus are displayed
DD/MM/YYYY YYYY/MM/DD]
60
] . Press [-, +]
EV2 Series DVR