Multi-Screen Display And Sequencing; Screen Display; Multi-Screen Display And Switch Sequencing Display - Nuvico EV2-400 Instruction Manual

2. Multi-screen Display and Sequencing

2.1. Screen Display.

Select any camera for Full screen display by pressing the Number button of the
desired camera.

2.2. Multi-screen Display and Switch Sequencing Display.

1) Press [DISPLAY] buttons to activate the multi-screen display. It is changed the
order as shown below among your choice of SPLIT MODE.
2) To start Auto Sequence, press [DISPLAY] buttons for 2 seconds to begin full
screen sequencing.
Click this ICON by
you will see following virtual controller
Main Monitor
Spot Monitor
SPLIT MODE
3) The sequence mode and dwell times are programmable. For detailed information
about configuring those, see "Switch Setup".
activated, it moves to Quad mode instead of Sequencing.
4) The Split mode is programmable in General set up.
Mouse and spot button on the remote control,
19
Auto Sequence Status
Auto Sequence
If the sequence mode is not
EV2 Series DVR