Printing Preparation - 3D Systems Cube User Manual
2nd generation
Hide thumbs
Also See for Cube:
- User manual (121 pages) ,
- Quick start manual (32 pages) ,
- Lesson (15 pages)
Table of Contents
Advertisement
21
PRINTING PREPARATION
NOTE: The Cube Stick™ will have to be applied on the print pad every time you start a new creation.
Caution: Do not use any other type of glue other than Cube Stick. Doing so can damage your print
tip and the print pad.
1. Stand Cube Stick on it's cap until the glue flows to the cap; remove cap.
2.
Remove print pad from the Cube; slowly apply a coat of glue in rows moving the bottle up and then down until the
glue is evenly distributed on the entire print pad. Check the pad after applying the glue to ensure there are noticeable
gaps where glue was not applied. If so, apply glue to the gaps.
3.
Replace glue cap after use.
4.
Place print pad on the print pad platform.
41
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Cube and is the answer not in the manual?