Removing Raft; Removing Supports - 3D Systems Cube User Manual

Removing Raft (If Required)
• If supports are present, use small pliers first to remove support from part. Use pliers to remove the raft away from the bottom of
your creation. In places where the supports are inside your creation and are hard to reach, use little wire snips or needle nose
pliers to remove the supports.
Removing Supports (If Required)
• Carefully break the supports away from your creation. In places where the supports are inside your creation and are hard to
reach, use small needle nose pliers (not supplied) to remove the supports.
52