3D Systems Cube User Manual page 35

2nd generation

Hide thumbs Also See for Cube:

Table of Contents

Continue to hold button until "Settings Saved" and then "Cube Firmware Loader [XX]" appears on the touch screen.

You are now in the correct mode to update your firmware. NOTE: Be sure to disconnect the USB cable after you have

updated your firmware.

5. Open Cube Software and click the "Configure" icon; click on "Load New Cube Firmware." Once you see the pop-up mes-

sage "Firmware Updated Successfully", click OK.

Disconnect the USB cable from your Cube and computer; unplug the Cube power cord. Plug power cord back in and

press the Cube power button (front button); a message will display on the touchscreen "Settings restored," click on the

check mark to save settings. This does not change your previous settings that you have made. Your new firmware is

Table of Contents

Show Quick Links

Table of Contents

Need help?

Do you have a question about the Cube and is the answer not in the manual?