Engine Oil; Check The Level; Replacement - Beta RR 350 EFI Operating Instructions Manual

4
GB
2
1
1
2
15Nm

ENGINE OIL

CHECK THE LEVEL

When engine is cold check the oil level by
means of porthole 1. The oil level must be
always visible from the porthole.
In contrary case restore the oil level through
cap 2 up to the upper edge of the inspec-
tion window.
Use the oil indicated on page 14 in
the "Recommended lubricants and liquids"
table.

REPLACEMENT

Always perform the replacement when
engine is hot:
- Position the drive on a flat base ensuring
stability.
- Remove the engine casing by loosening
the screws shown in the figure.
- Place a container under the engine.
WARNING:
Hot oil can cause severe burns!
- Unscrew filler plug 1 and drain plug 2.
- Remove the wire mesh filter.
- Drain all the oil from the crankcase.
- Thoroughly clean the drain plug, the wire
mesh filter and the sealing surfaces.
- Mount the wire mesh filter and the drain
plug.
- Tighten to the torque indicated.
40