Checks Before And After Use; Running In - Beta RR 350 EFI Operating Instructions Manual

2

CHECKS BEFORE AND AFTER USE

For safe driving and long vehicle life you should:
1 Check all fluid levels.
2 Check the correct operation of the brakes and brake pad wear (page 48).
3 Check pressure, general condition and thickness of tread.
4 Check that the spokes are properly tightened.
5 Check the tensioning of the chain (page 61).
6 Check the adjustment and the operation of all the cable controls.
7 Inspect all the nuts and bolts.
8 With the engine running, check the operation of the headlight, the rear and
brake lights, the indicators, the warning lights and the horn.
9 Wash the motorcycle thoroughly after off-road use (page 67).

RUNNING IN

The running-in period lasts approximately 15 hours, during which it is advisable to:
1 During the first 3 hours of operation the engine should only be used to ap-
proximately 50 percent of its power. In addition, the engine speed should not
exceed 7,000 rpm.
2 For the next 12 hours of operation the engine should only be used to about
75 percent of its power.
WARNING
After the first 3 hours change the engine and gear oil.
This procedure should be followed each time piston, piston rings, cylinder, crankshaft
or crankshaft bearings are replaced.
GB
26