Beta RR 350 EFI Operating Instructions Manual page 41

To change the paper filter, remove the oil
tap form engine unscrewing the two screws
3. Using special seeger ring pliers, pull the
paper oil filter.
Mount the new paper filter, close the oil tap
to engine, tighten the screws at 10 Nm.
Pour in the quantity of liquid indicated on
page 11.
Use the oil indicated on page 14 in
the "Recommended lubricants and liquids"
table.
- Screw on filler cap 1 again.
- Start the engine and run at idle for a few
minutes.
- Turn off the engine and wait for about one
minute, then check the level and top up
if needed, without exceeding the upper
edge of the inspection window.
WARNING:
Hot oil can cause severe burns!
ATTENTION:
Dispose of used oil in compliance with the
regulations in force.
Re-assemble the engine protection plate by
tightening the screws to 10Nm.
3
10Nm
41
4
1
GB