Adjustment Of Gas Clearance; Idle Adjustment; Handlebar Adjustment; U-Bolt Position Adjustment - Beta RR 350 EFI Operating Instructions Manual

ADJUSTMENT OF GAS
CLEARANCE
The throttle control cable should always
have a 3-5 mm play. In addition, the idle
speed should not change when the han-
dlebars are fully rotated to the left or right.
Push back protective cap 1. Loosen coun-
ternut 2 and turn adjusting screw 3.
Tighten the counternut and check that the
throttle twist grip turns smoothly.

IDLE ADJUSTMENT

The minimum speed is controlled directly
by the electronic control unit. Any manual
adjustment is not allowed.
WARNING! Do not modify the indi-
cated screw for any reason. Modify-
ing the position of this screw may
cause abnormal response behaviour
and engine operation. Moving the
indicated screw, in terms of the war-
ranty, is considered tampering.

HANDLEBAR ADJUSTMENT

U-BOLT POSITION ADJUSTMENT

The lower bracket 1 can be mounted on
the holes nr. 2, 3 or 4 respectively.
1
1
2
3
33
2
3
2
3
4
4
3
GB