Engine Throttle Bracket; Workman Hdx--D; Briggs/Daihatsu Diesel Engine - Toro Workman HDX Service Manual

Engine Throttle Bracket

12
9
8
7
2
10
RIGHT
FRONT
1. Engine
2. Lock nut
3. Cap screw
4. Throttle bracket
5. Flange nut
Disassembly (Fig. 15)
1. Remove throttle bracket components from engine as
needed using Figure 15 as a guide.

Briggs/Daihatsu Diesel Engine

7
8
6
2
7
13
11
Figure 15
6. Throttle bellcrank
7. Ball joint
8. Jam nut
9. Threaded rod
Page 4 - - 18
3
4
5
10. Accelerator cable
11. Return spring
12. Shoulder bolt
13. Grease fitting
Assembly (Fig. 15)
1. Install removed throttle bracket components to en-
gine using Figure 15 as a guide.
2. Lubricate bellcrank grease fitting (item 13) after as-
sembly.
3. Check operation and adjustment of accelerator
cable (see Operator's Manual). If needed, adjust accel-
erator cable.
4. Check engine speed (both idle and high idle) and ad-
just if necessary (see Adjust Engine Speed in Adjust-
ments section of this chapter).
1

Workman HDX--D