Front Differential Disassembly - Toro Workman HDX Service Manual

Front Differential Disassembly

1. Make sure that the oil is drained from the differential
assembly.
2. Remove the four (4) flange head screws from the in-
put cover (Fig. 11). Remove the cover.
3. Remove the pinion shaft from housing by pulling it
out of the gear case by hand (Fig. 12).
4. Inspect the inner pinion bushing in the gear case
(Fig. 13). If the bushing is excessively worn, the gear
case must be replaced. The bushing is not serviced sep-
arately.
Workman HDX/HDX--D
1
1. Input cover
2
1. Pinion shaft
1
1. Pinion bushing
Rev. A
Page 10 - - 15
2
Figure 11
2. Pinion shaft
1
Figure 12
2. Gear case
2
Figure 13
2. Gear case
Front Wheel Drive (4WD)