Toro Workman HDX Service Manual page 99

7. Loosen and remove fifteen (15) flange head screws
and separate center plate from transaxle case. Note
dowel pins in transaxle case. Remove seal cap (item 1),
shims (items 2 and 4) and snap ring (item 3) from center
plate.
8. On 4WD units, remove front drive shaft and 41T
gear from the gear case. Remove bearings from gear
case (Fig. 29, item 2) and center plate.
9. Remove reverse shaft (item 1) from transaxle case.
10.Remove main shaft assembly (item 1) together with
fork shaft assembly (item 2) from transaxle case.
Workman HD Series
3
1
BEARING
(CENTER PLATE)
1
Page 6 - - 23
2
Figure 27
FRONT DRIVE
SHAFT
BEARING
(GEAR CASE)
41T GEAR
Figure 28
Figure 29
2
1
Figure 30
Drive Train
4
2