Toro Workman HDX Service Manual page 292

12.Place the cover plate on the workbench with the male
output hub facing up.
13.Using a screwdriver, remove the internal retaining
ring from the cover plate (Fig. 20).
14.Remove the gear spacer from the cover plate (Fig.
21).
15.Remove the armature plate from the cover plate (Fig.
22).
IMPORTANT: When removing male output hub from
cover plate, be careful to not damage the seal in the
cover plate. The seal cannot be serviced separately.
16.Turn the cover plate over and place it on blocking or
in a vise. Using a hammer and suitable punch, carefully
remove the male output hub and bearing from the cover
plate by driving the output hub down. The bearing has
a slight interference fit to the bore of the cover plate. Be
careful to not damage the seal in the cover plate.
17.Discard the removed output hub assemblies. Clean
and inspect all removed parts.
NOTE: For additional front differential information, see
the Hilliard Front Drive Differential Parts and Service
Manual at the end of this chapter.
Front Wheel Drive (4WD)
1. Male output hub
2
1. Male output hub
2
1. Male output hub
Rev. A
Page 10 - - 18
2
Figure 20
2. Retaining ring
Figure 21
2. Gear spacer
Figure 22
2. Armature plate
Workman HDX/HDX--D
1
1
1