Toro Workman HDX Service Manual page 41

Disassembly (Fig. 19)
1. Remove throttle bracket components from engine as
needed using Figures 19 and 20 as guides.
Assembly (Fig. 19)
1. Install removed throttle bracket components to en-
gine using Figures 19 and 20 as guides.
2. If removed, attach governor spring to governor link
rod and center slot in engine governor lever (Fig. 21).
3. Lubricate bellcrank grease fitting after assembly.
4. Check engine speed (both idle and high idle) and ad-
just if necessary (see Engine Speed Adjustment in Ad-
justments section of this chapter)
5. After engine speed has been checked and adjusted,
check operation and adjustment of accelerator cable
(see Operator's Manual). If needed, adjust accelerator
cable.
Workman HDX
3
1. Governor spring
2. Bellcrank
3. Return spring
4
2
1. Engine governor lever
2. Governor spring
Page 3 - - 23
2
Figure 20
4. Accelerator cable
5. Governor link rod
3
Figure 21
3. Spring mounting slot
4. Governor link rod
Briggs/Daihatsu Gasoline Engine
5
1
4
1