Toro Workman HDX Service Manual page 97

Clutch Disassembly and Inspection (Fig. 19)
1. Insert clutch alignment tool (see Special Tools) in en-
gine flywheel pilot bearing hole to keep clutch disk from
falling off (Fig. 20).
2. Loosen pressure plate cap screws (item 10) in a diag-
onal sequence.
3. Remove cap screws, lock washers (item 11) and
pressure plate (item 12), then slide out the alignment
tool and remove clutch disk (item 13). Note orientation
of clutch disk as it is removed (Fig. 21).
4. Inspect diaphragm spring end of pressure plate for
wear and uneven height. Replace if wear is evident or if
height difference exceeds 0.020 in. (0.5 mm).
5. Check pressure plate surface for wear, cracks or col-
or change.
6. Check strap plate rivets for looseness. Replace pres-
sure plate if rivets are loose.
7. Check clutch disk facing for loose rivets, uneven con-
tact, deterioration due to seizure and lubricant contami-
nation. Replace clutch disk if damaged.
8. Measure rivet sink and replace clutch disk if out of
specification (Fig. 23).
Clutch disk thickness
standard value
Clutch disk rivet sink
9. Check for torsion spring play or damage. Replace
clutch disk if necessary.
10.Install clutch disk on transaxle main shaft. Make sure
clutch slides freely on splines of shaft. Check for exces-
sive play in rotating direction.
11. Inspect flywheel surface for stepped wear, streaking
or seizure. Replace if necessary. Clean any oil or rust
from flywheel surface with light abrasive. Check flywheel
runout and replace if runout exceeds 0.005 in. (0.13
mm).
12.Inspect flywheel pilot bearing for wear or damage.
Replace pilot bearing if necessary.
Installing Clutch Disk and Pressure Plate
1. Apply a coating of grease to clutch disk spline, then
use a brush to rub it in. Wipe off any excess grease.
2. Use clutch alignment tool (see Special Tools) to posi-
tion clutch disk to engine flywheel.
Workman HD Series
0.307 to 0.339 in. (7.8 to 8.6
mm)
0.012 in. (0.3 mm) minimum
Page 6 - - 21
3. Install pressure plate. Install and tighten six (6) cap
screws and lock washers a little at a time, working in a
diagonal sequence. Torque screws from 5 to 7 ft- -lb (7
to 9 N- -m). Remove alignment tool from flywheel bear-
ing after pressure plate is installed.
Figure 20
Clutch Disc
Engine
Flywheel
Side
Figure 21
Pressure plate
Torsion spring
Figure 22
Figure 23
Clutch Alignment Tool
Pressure
Plate Side
Diaphragm spring
Rivet sink
Drive Train