Polaris 2009 Sportsman XP 850 Service Manual page 223

NOTE: Rotate the ring gear to align the locating pins
and holes during installation.
11. Install the armature plate. Verify the armature plate tabs
align with tab recesses in the roll cage.
12. Install the female output hub assembly into the roll cage.
NOTE: Rotate the output hub to align the locating
pins and holes during installation.
13. Install the large O-ring onto the cover plate and small O-
ring onto the main gearcase.
14. Lightly crimp the thrust pad to hold the pad on the cover
plate during installation.
15. Place the cover plate assembly on the main gearcase and
install the (6) screws. Torque screws to specification.
IMPORTANT: Take care not to damage the seal lip or
seal spring while installing the cover plate.
Cover Plate Screws:
7-11 ft. lbs. (9-15 Nm)
16. Install the piston pump assembly with new O-rings.
Torque the screws to specification.
Pump Assembly Screws:
15 in. lbs. (1.7 Nm)
IMPORTANT: If the cover plate was replaced or if the
backlash set screw was repositioned, proceed to the
"Setting Ring Gear Backlash" procedure.
FINAL DRIVE
= T
= T
8.21
8