Table of Contents
Advertisement
6-7
Installing Expansion Cards
The system supports two full-height, half length PCI Express expansion cards. They
are installed using a riser card and riser bracket.
Installing Expansion Cards
1. Remove the riser card bracket from the chassis by unscrewing only those screws
inidcated by the screwdriver icon as illustrated in Figure 6-7.
2. Lift the riser card bracket from the chassis.
3. Install the riser card on the bracket using the two screws provided.
4. Open the latch on the end of the bracket.
5. Install the expansion card by sliding the card into the appropriate slot in the riser
card, and then close the bracket latch over the end of it.
Figure 6-7. Removing the Riser Bracket
Chapter 6: Advanced Chassis Setup
6-9
install add-on card
Advertisement
Table of Contents
