Lamp Installation - Chauvet followspot 1200 User Manual

Lamp Installation

Installing a new lamp requires caution. Follow the steps indicated below to complete
the lamp installation in a safe manner.
If you touched the lamp with your bare hands, make sure to clean it thoroughly
(contacts, glass necks and glass globe) with isopropyl alcohol and wipe it with a
lint-free cloth before installing it. Otherwise, the fingerprints on the lamp may
shorten its life and even cause damage to the optical assembly.
Follow all the safety instructions indicated on page 8.
Installing a
1) If installing a new lamp, open the Followspot 1200 as indicated on page 8.
New Lamp
2) Before installing the lamp, loosen its end screws.
3) Hold the lamp by its metallic contacts and slide it into the slots.
4) Ensure that the flat washers on the lamp shafts are on the thumbscrew side of the
5) Evenly push the clips backward to allow the lamp to go all the way into the slots.
6) Rotate the lamp until the nipple is on the top of the bulb.
7) Tighten the lamp end screws.
8) Once installed, the lamp should look as in the diagram bellow.
Lamp Installation
Diagram
Closing the Fixture
1) Close the lamp cover and tighten the thumbscrew that holds it.
2) Slide the front cover backward until it touches the bracket.
3) Tighten the thumbscrew to secure the front cover.
slot to ensure maximum contact.
Flat
washer
Clip
Reflector
Clip
Lamp end
screw
-9-
Setup
Lamp end
screw
Contact
plate
Bulb
nipple
Fixture's
front
Lamp
contact
Contact
plate
Followspot 1200 User Manual Rev. 5